How to deal with air compressor failure CO1?

The main reason for screw air compressor failure C01 refers to host imbalance, which means that the three-phase voltage of the host is unbalanced. This fault usually occurs during the operation of the air compressor and may cause the air compressor to trip or shut down. The following is how to deal with this fault:

1. Check the power supply: First check whether the power supply wiring of the air compressor is correct and whether there is a phase loss or circuit break. If there is a problem with the power supply, the power supply line needs to be repaired.

2. Check the load: Check whether the air compressor host is overloaded. If the load is too large, it may cause voltage imbalance. At this time, it is necessary to reduce the load, such as turning off some uncommon equipment or reducing the power of the load.

3. Check the motor: Check whether the motor of the air compressor is working properly. If the motor is faulty, the motor needs to be replaced.

4. Check the pressure controller: The pressure controller is an important part of the air compressor. If the pressure controller fails, it may also cause voltage imbalance. At this time, it is necessary to check the settings and adjustments of the pressure controller.

5. Check the wiring: Check whether the wiring of the air compressor is loose or in poor contact. If this is the case, rewiring or replacing the bad wiring is required.

6. Seek professional help: If the above methods cannot solve the problem, it is recommended to seek help from professional air compressor maintenance personnel. They can find the cause of the fault through inspection and testing and repair it.

In short, to deal with screw air compressor fault C01, you need to carefully check the cause of the fault and take appropriate treatment methods according to the specific situation. If you are not sure how to deal with it, it is recommended to seek help from professionals to solve the problem in time.